project:medlab:sono
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| project:medlab:sono [2015/11/10 01:08] – grammar nazi (stejně neumím anglicky, takže to je asi ještě horší než to bylo) jenda | project:medlab:sono [2015/11/11 00:30] (current) – sachy | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ===== Medlab sono user guide ===== | ||
| + | This simple user manual should be the starting point and a minimal knowledge base for anyone who wants to operate the sonograph in medlab. | ||
| + | |||
| + | Full documentation is available in medlab. | ||
| + | |||
| + | |||
| + | == Boot == | ||
| + | - Turn on the red switch on the far left side of the operator panel | ||
| + | - Take a look on the panel under the screen - every LED should be on | ||
| + | - Do NOT touch any other button in the area | ||
| + | == Subject preparation == | ||
| + | - Undress subject as appropriate | ||
| + | - Put some sonogel on the subject where appropriate | ||
| + | - Put sono head to the subject, so the insides should be visible on the screen | ||
| + | == Object measurements == | ||
| + | - B mode - depth(y) x longitude(x) | ||
| + | - The skin surface is on the top of the screen | ||
| + | - Horizontal axis displays centered longitude | ||
| + | - M mode - depth (y) x time (x) | ||
| + | - Vertical axis is depth | ||
| + | - Horizontal axis is time seprated by line each 1 sec | ||
| + | - Doppler - TODO | ||
| + | == Tips and tricks == | ||
| + | - Freeze - pause image | ||
| + | - Next to Gain (lower right) | ||
| + | - Distance measurement | ||
| + | - M mode | ||
| + | - Cursor is displayed on the screen | ||
| + | - Use trackball to navigate to starting point | ||
| + | - Press Channel 1 | ||
| + | - Navigate to the end point | ||
| + | - Press Channel 1 | ||
| + | - (Repeat with Channel 2 is appropriate) | ||
| + | - B mode | ||
| + | - Basically the same as M mode | ||
| + | - Trace | ||
| + | - Draw on screen | ||
| + | - Trackball on starting point | ||
| + | - Channel 1 | ||
| + | - Trackball draws line | ||
| + | - Channel 1 closes the circuit | ||
| + | - Repeat with Channel 2 if appropriate | ||
| + | - Press Trace again to leave | ||
| + | - Ellipse - draw ellipse | ||
| + | - Trackball on one end of primary axis | ||
| + | - Channel 1 | ||
| + | - Trackball to the end of primary axis | ||
| + | - Channel 1 | ||
| + | - Use trackball to modify the secondary axis of the ellipse/ | ||
| + | - Repeat with Channel 2 if appropriate | ||
| + | - Press Ellipse to leave | ||
| + | - Notes - Type text on screen | ||
| + | - Press Char | ||
| + | - Trackball on position | ||
| + | - Type the text | ||
| + | - Repeat ^^ | ||
| + | - Compatible with measurement mode | ||
| + | - Press Char to clear the text | ||
| + | |||
| + | |||
| + | Recording: the machine has composite video output. There is an USB grabber connected. Use mplayer to view and something like cheese (from Gnome) to capture, or VLC to view and capture/ | ||